next up previous contents index
Next: Single and Multi-dish mode Up: Flux measurements with the Previous: Calibration Procedure   Contents   Index

Observing procedure

The procedure FLUX (corresponding to the project FLUX) is similar to BASE or POINT and runs under the OBS program. This procedure makes flux measurements in single-dish, multi-dish or interferometric mode. For commodity and a better calibration accuracy, it uses only the two following frequencies: SiOv1 at 86 GHz and 13CO(2-1) at 210 GHz. A third option allows using the current frequency tuning for only SMALL ``holes'' between two projects.

To start it, just type @ PR:FLUX then answer the questions about frequency choice, observing mode and so on...


Gildas manager 2014-07-01