VARIABLES

        CLIC\VARIABLES group ON|OFF

    *** THIS HELP HAS NOT BEEN UPDATED FOR THE NGRX ***

    This command is used to create/delete CLIC  variables  corresponding  to
    header  information.  Several  groups of variables are available, corre-
    sponding to sections in the scan headers.

      READ_WRITE     Input/Output file information (Global)
      GENERAL        General information (Scan based)
      POSITION       Source related information (Scan based)
      CONFIG         Array configuration related information (Scan based)
      RF_SETUP       Receiver related information (Scan based)
      CONTINUUM      Continuum correlator related information (Scan based)
      LINE           Spectral correlator related information (Scan based)
      SCANNING       Special scanning information (Record based)
      ATMOSPHERE     Atm. calibration parameters and results (Scan based)
      MONITOR        Total power monitor information (Scan based)
      WVR            Water Vapor Radiometer information (Scan based)
      DESCRIPTOR     Data descriptor information (Scan based)
      DATA_HEADER    Data header information (Record based)
      DATA_RECORD    Data values (Record based)

    Scan- or record-based variables refer to the last scan  or  record  that
    has been read (explicitely by GET/RECORD, or implicitely by PLOT or oth-
    er commands).