next up previous contents index
Next: Amplitude Calibration Up: Phase Calibration Previous: Determining the calibration curve   Contents   Index

Storing the Phase Calibration Curves

The next step is to store this curve (if satisfactory) in the headers of the observations to be calibrated. This is done after loading those observations into the current index, by the STORE PHASE command. Before doing this, you must have selected an output file. This may either be the same as the input file (the headers will then be modified in place), or a new file.

CLIC will not apply the calibration to the data itself before it is processed Calibrated data may be examined however with the PLOT command; to do this you have to enter the command SET PHASE RELATIVE . This will be switched back to ABSOLUTE if you try to use SOLVE PHASE on calibrated data.

Gildas manager 2014-07-01