next up previous contents
Next: Status of the CLASS Up: Tuning of the addition Previous: Position matching   Contents

Calibration matching

        LAS\SET CALIBRATION [Beam_Tol [Gain_Tol]] or OFF

    Specify the tolerance on the Beam efficiency (Beam_Tol) and  gain  image
    ratio (Gain_Tol), on turn or calibration checking. A value of 0 means no
    check. The default values are 0.02 and 0 respectively.

    These values are used by commands ACCUMULATE and AVERAGE to verify  that
    the calibration is consistant. They are also used by command WRITE which
    writes the corresponding information in the output file only if Beam_Tol
    is  non  zero. Note that because the beam efficiency is less than 1, you
    could use Beam_Tol=1 to suppress  the  calibration  checking  but  still
    write the information.



Gildas manager 2014-07-01